Hi all, does anyone know if its possible to adjust the clutch on a 2wd '90 Masterace? I don't think you can, as its hydraulic, which leads me to my second question.
Was going to bleed the clutch fluid & replace with new, but there are two bleed points within a few inches of each other, which one do you use, or do you use both? Is there any special set way to bleed the clutch using these bleed nipples?
As usual, will wait for divine intervention from 'The Masters'- David & Ian, or maybe 'Yoda' himself Roger.B!
Cheers guys,

Take it easy, regards,

Tony.

- (#4057) Tony Lloyd-Jones, 31 Jul 02

AFAIK the slave cylinder (and we are talking about the slave cylinder are we not?) only has one bleed nipple close to the fluid entry and slightly above it. The clutch pedal can move a bucket load of fluid so be careful not to drain the master cylinder when bleeding!
I had a quick look on the Russian Catalogue site
http://www.elcats.ru/toyota/fullimg.asp?piid=30896&mid=116&cid=321&fulldate=01/01/1991
and this confirms one bleed nipple.

- (#4062) clive, 1 Aug 02