(Home) Glow plug wiring

havin a mare rebulding my 2ct engine, i wasnt involved in the strip down and am at loss as to where a wire is meant to go, ive got 3 wires coming up from wiring loom around starter 2 of which i know goto heater plug wiring as shown in toyota 2ct manual the 3rd one is a brown wire with a ring (washer type)connector not sure if it goes to heater plug with overs or to earth elsewhere .any advice apreciated ,,,,,,,,,,,,
p.s
i could email a picture if it would help ,,,,,,,,,

- (#5779) mitch, 12 Oct 02

earth wire to the injector clamp is a ring with two white/ black wires IIRC. There's a small ring and a big ring that go onto the glowplug resistor. Big black spade connects to the other end of the current sensor. Small green wire with space is temp sensor.

- (#5780) david miller, 12 Oct 02

cheers Dave ,
but still no luck the wires you mentioned are all in place but I have no idea where this third one goes,it comes from same part of loom as heater plug wiring but spurs of just below it a brown wire in a black sleeve ,is there anybody who can throw light on this please,only nead my injectors in & this wire to sort & hopefully I'll be up & running

- (#5781) mitch, 13 Oct 02

Ah, OK. just looked at mine in the flesh, as it were. The earth leads are white/black and brown, both on a single eyelet.
Don't see any other browns.

- (#5782) david miller, 13 Oct 02

david,
hope you dont mind ,just emailed you a photo of my wiring prob .Hope yoou can help,

- (#5783) mitch, 13 Oct 02

david,
my wiring must be totaly different to yours got it running I have a black/white on inside of connection & a black on outside the brown wire I have put to earth at the injection pipe clamp noticed marks on washer that were same as back of nut so crossed my fingers,
cheers Mitch

- (#5829) mitch, 14 Oct 02