I need to find terminal screws behind the instrument panel for the "+12V" supply (ignition switched) and 0V earth. These are for wiring in an overtemperature alarm. I have a picture of the back of the panel (the red arrow shows the temperature gauge connection). Any suggestions. It's not for my car, so I can't investigate personally.
Since the link below will disappear when a reply is posted, I'll add the link here, also one for the front view which shows the new transmission indicator.
rear:
http://www.mpvi.net/ia/pic.htm?pic=../ig/igdasr92.jpg
front:
http://www.mpvi.net/ia/pic.htm?pic=../ig/igdasf92.jpg

- (#9200) Dave Mason, 21 Jun 03 14:23

I see you are asking for the terminals on the dashboard for the gauge. Is this for my unit when it arrives ????? If not i need that diagram too as mine is the same dashboard as what you have pictured. Thanks.

- (#9201) Bruce Van Essen, 21 Jun 03 19:14

Bruce - all part of the Townace mystery that we're solving together, and the reason that I'm offering the alarm on trial at a discount. Diagrams etc will come to you soon by email.
No, the question actually arose for another owner of the newer model. All previous installations had been on '90/'91 models.
We now have a tentative solution but I'd still welcome any advice, as always.
- (#9255) Dave Mason, 23 Jun 03 3:44

I'm nearly there with tuning the overtemperature alarm for the later models. If you live in the Worthing area, have one of these later models (see dash front picture above) and would be willing to join in this project please contact me by email. If it proves necessary it would be good to make a few measurements on one of these models myself. You'd get a temperature alarm fitted in the process.

- (#9291) Dave Mason, 24 Jun 03 4:07