Does anyone know how to get an EMINA dashboard out to get to the speedo. I have to change the speedo face, and replace the O/D lamp.
- (#8658) Pete Bulley, 19 Feb 04 11:59

You need to remove the surround around the heater controls this is clipped with 2 small locating lugs at the back end, there should be 2 screws behind this, remove these then open both front doors & with a small flat blade such as a putty knife, from the outer edges carefully pull the black trim out & forward. Then along the top edge carefully unclip the trim, you can then remove the dash surround. You can go to "estimaclub.co.uk" where there is a better detailed instructions. When replacing the speedo needle you must switch the ignition on or start the engine otherwise the speedo will read wrong

- (#8658) Arshad Mahmood, 21 Feb 04 05:10