Hi All
Can anybody help me with a couple of problems please.
Firstly, the pulley and shaft of the power steering pump hve just come off. Has anybody got a parts drawing so I can put a new bearing in or has anybody got a Powersteering pump for sale.
Secondly, I am haveing the vacume problems. I got a garage to do an engine replacement which I supplied and when they finished they said the 4wheel drive did not work and also the Overdrive. On checking there were some of the vacum pipes that were pinched with a tie and not connected and the OD solinoid was faulty. I have downloaded the drawing from Ace Answers for the vacume pipes but there is one that is still not connected and is not shown where it is connected on the Ace Answers drawing. It is the pipe marked M. Can anybody help. I have connected all the other pipes but for this one and will not be using the garage again. It is back to if you want something done properly do it your self. Help...

- (#10868) Graham Rose, 13 May 04 12:01

Hello Graham,
pipe M is the pipe from the vacuum pump and it feeds over the top of the engine with another pipe L.

- (#10868) dave Bright (Bournemouth), 13 May 04 14:44

Thanks Dave

I will try and work it out. Where does it go because it seems to go to the lower front. I do have one that looks as though it goes to the pump and that is pipe E. I could do with a better drawing to help if there is one about but thanks again.

- (#10868) Graham Rose, 13 May 04 18:10