THe window has come out of it`s runner and I`d like to know the best/easiest way of getting it back in please. Electric window on Townace MasterAce Surf H reg.
I`ve taken the window out and door trim off but am not sure how to get the rubber runner thing out to stick the window back in... or what tools I might need to do it.
Cheers.

- (#13678) Storm, 9 Oct 04 08:50

The rubber thing?
Do you mean the bit that goes around the inside of the window frame or the the bit that attaches to the bottom of the glass?
The bit at the bottom which bolts to the regulator is a push/tap fit. The weather seal rubber should be left in place. The lower part on the rear of the door is held in place by a bolt at the bottom. Squirt some washing up liquid on your finger and run it around the rubber, wet the edge of the window, lower it into the door as low as it will go, then wriggle it up into the rubber. Slide up and attach to the regulator with the lower rear part likewise lubed fix it in place if it was moved and tighten the bolt.
Test the movement of the glass by attaching the door switch before putting the door card back on!

- (#13678) Clive (Bristol), 9 Oct 04 13:24

Hi this happened to me some time ago.I found that the sliding bar had slipped out of the runner,so I had to open up the runner and fit the sliding bar back in then tap the runner up gently to close it on the sliding bar.
The sliding bar pushes the window up and brings it down.

- (#13678) Liam, 9 Oct 04 15:27