Hello to all, once again i need to tax your bonce's
After lots of clutch trouble (you might remember my past post's) i decided to change the clutch pressure plate & had lots of fun removing the gear box. But much to my horror i found out that the Clutch release fork has split and so the clutch slave cylinder was not pushing the clutch release fork properlly as it is split which means
1) iv'e gone and spent £170 on a clutch kit for nothing (Bugger)
& 2) Can some kind person please tell the part Number for a Clutch release Fork,

Many Thanks
Dan
- (#1035) Dan, 30 Apr 05 16:36

Part no 31204-20071 for CR2* CR3* so same for 2wd and 4wd for years 8808 - 9201
this is the arm that goes from slave cylinder push rod to cluych release bearing.

- (#1035) Clive (Bristol), 30 Apr 05 17:35

... and it's a fairly common part used in UK and Euro models like the Previa and Hilux.

Or you could bend the old one back into line and weld it perhaps?

- (#1035) David Miller, 30 Apr 05 18:13

Once again Clive and David to the rescue thanks guys.
Thought about getting it welded but the Clutch release fork is cast and has to take a lot of pressure from the slave cylinder and i wouldn't trust it to take the strain. The last thing i want to do is replace the gear box back into me beloved van and then have to take it back out again.

The bugger is me van only just passed it's first MOT last week since i've owned it and then the clutch (as i thought it was) went 3 days later. Bugger.
Wont be long and i will be almost as good as a qualified mechanic, all thanks to my ever need to fix the familly Bus.

Cheers Guys.
Dan

- (#1035) Dan, 1 May 05 06:09