got the dreaded sqeaky suspension and after looking at the archives decided that the wishbones needed some grease.

only problem, felt under over and around and cannot find a blanking screw/bolt were i could screw in a nipple. is it possible that my townie has sealed units?

1991 townie,superace td.

any directions would be appreciated, confidence has taken a knock much to the missus amusement that i can't find a nipple point.

- (#1153) Dennis, 7 May 05 11:31

I think on the top middle outer edge (over the ball joint) of the wishbone there is a 10mm nut which can be replaced with a nipple.....also in the middle but between the wishbone ends is another 10mm nut for same.....don't know about sealed units......

- (#1153) chris turner, 7 May 05 16:25

thanks Chris,guess i'll be looking this weekend.

- (#1153) Dennis, 11 May 05 16:07

don't put too much grease in the ball joint side though, as the ball joint gaiter fills up with grease like a balloon if your'e too eager............

- (#1153) chris turner, 12 May 05 17:58